Flanges are available in lengths of 1 1 1 1.
Z bar flashing installation.
Check out our recommended tools right here.
Galvanized steel unless specified.
Thd sku 686080.
When installing the flashing the longer edge goes against the wall of the house the center section rests on top of the casing and the.
Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing.
Steel z bar flashing with 2 in.
The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding.
The seat dimension 3 8 in corresponds to the siding thickness.
Bailey s z bars are ideal for many construction applications such as continuous framing insulation reinforcement slides track and roofing.
Place the z flashing into position on top of the casing.
Z bar flashing provides an inexpensive and easy to install method of stopping water penetration behind siding.
Test the rotted area of the t1 11 siding by poking it with a nail or a screwdriver.
Designed for roofing applications.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
It is used to protect the horizontal joints between sheets of siding from water infiltration.
Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if.
Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud.
How to install z flashing on rotted t1 11 siding 1.
Install the first length of z flashing.
The z bar is available in 018 033 043 054 thickness of steel.
Z bar design easily accommodates rigid insulation.
Galvanized steel z flashing is made from 28 gauge galvanized steel.
If only the surface is damaged.
Backleg made of 28 gauge galvanized steel.
